You are reading a single comment by @M_A_X and its replies. Click here to read the full conversation.
  • All mitred up, i made a pretty shonky jig, clamping th BB shell to the (relatively) flat welding table, i figure out my centre line and went from there, using some tube blocks (found a 32mm holesaw, very convenient for my 31.8 tubes) and other bits of scrap flat bar to get the tubes in the right place :

    tacked it all up:

    might make the headtube a bit shorter on the top.

About

Avatar for M_A_X @M_A_X started