You are reading a single comment by @Dammit and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Dammit
If drilling a hole into a carbon fibre stem, would it be advisable to epoxy a metal plate over the are to be drilled, and drill through it and the carbon underneath, or is that pointless?
Hole diameter to be 1-2mm, and (current) intended location of hole to be underside of stem, where one might find a hole on an old MTB stem that was designed to be run with canti's, and therefore had a cable run through the stem.