For Sale: Kona P2 forks, Gilles Berthoud, 26 1.3/8 front wheel, sugino cranks, DMR tyres

Gilles Berthoud 50mm Stainless Steel Mudguards (26 inch wheels) - £25.00
Bought last August from SJS for my girlfriends bike and due to the fact they arent very simple to install (and they were the wrong size) they've never been used. Got them out of the shed and theres a few patches that look like rust, and a some water marks where it got under the celephane they came in but Im guessing if you get some metal polish on them it should be fine. Comes with all the fittings and more are available from SJS should you need them.

http://www.sjscycles.co.uk/gilles-berthoud-gilles-berthoud-mudguard-fitting-kit-prod20948/?src=froogle

26.1.3/8 westwood front wheel £15.00
Bought again for my girlfriends bike for £25.00 from here:
http://www.cycleparts.co.uk/product.php?productcategory_id=109&from=48
but i was after a westrick and not a westwood which has no breaking surface.

**Kona Project two forks (threaded) £25.00
**Had these on my old fire mountain back in about 1998. Not seen alot of action since then. Top of the thread looks a bit dodgy but If it could be taken off and used threadless? Any problems with these and you can have your money back.

Sugino messenger cranks 165 £25.00
comes with 42 tooth charge ring. The drive side crank is threaded.

24" DMR tyres £5.00 each
One moto and one moto digger.
Moto has some wear but the digger has only been used a few times at chicksands and has very little wear.

photos here: http://www.flickr.com/photos/thelostsoulcrusade/sets/72157626046657070/with/5444907720/

**Gilles Berthoud 50mm Stainless Steel Mudguards (26 inch wheels) - £25.00
**Bought last August from SJS for my girlfriends bike and due to the fact they arent very simple to install (and they were the wrong size) they've never been used. Got them out of the shed and theres a few patches that look like rust, and a some water marks where it got under the celephane they came in but Im guessing if you get some metal polish on them it should be fine. Comes with all the fittings and more are available from SJS should you need them.

http://www.sjscycles.co.uk/gilles-berthoud-gilles-berthoud-mudguard-fitting-kit-prod20948/?src=froogle

**26.1.3/8 westwood front wheel £15.00
**Bought again for my girlfriends bike for £25.00 from here:
http://www.cycleparts.co.uk/product.php?productcategory_id=109&from=48
but i was after a westrick and not a westwood which has no breaking surface.
Kona Project two forks (threaded) £25.00
Had these on my old fire mountain back in about 1998. Not seen alot of action since then. Top of the thread looks a bit dodgy but If it could be taken off and used threadless? Any problems with these and you can have your money back.

**Sugino messenger crankset 165mm £25.00
**comes with 42 tooth charge ring. The drive side crank is threaded.

**24" DMR tyres £5.00 each
**One moto and one moto digger.
Moto has some wear but the digger has only been used a few times at chicksands and has very little wear.

photos here: http://www.flickr.com/photos/thelostsoulcrusade/sets/72157626046657070/with/5444907720/

[B]
Kona Project two forks (threaded) £25.00
Had these on my old fire mountain back in about 1998. Not seen alot of action since then. Top of the thread looks a bit dodgy but If it could be taken off and used threadless? Any problems with these and you can have your money back.

Pretty sure threaded and threadless have different thickness metal so not sure this is possible.

What size are they?

Let me measure them tonight and I'll add it to the listing.

Pretty sure threaded and threadless have different thickness metal so not sure this is possible.

What size are they?

I've done this in the past, should be fine.

Its fine as long as the steerer tube is long to allow for the extra required to secure the stem

Threadless is commonly 1 1/8" but you can get 1" threadless headsets.

Its definately 1.1/8. The steerer is fairly long as the headtube on those old Kona's was pretty sizable. But I'll measure tonight, meant to do it this morning...

Hi, I'm still new to this. Could you tell me the difference between a threaded and non-threaded crank? And would the Sugino crankset be 144bcd?

Cheers

Dibs sugino crank £25. Ta.

any idea whether the guards will fit over 50mm schwalbe big apples? ta

hi there the p2's are as follows: Steerer tube is 183mm and axle to crown is 370mm.

the crank thread is used to lever the crank off the Bottom bracket when you want to remove it. As its stripped it means you have to resort to other methods to remove it.

Sorry not too sure on the guards. I guess as they are 50mm wide it might be a squeeze. If youre in London I could meet you Central and you can check it out if you like?

Luke Skywalker pulled out. All items still available.

Fine, I'll 'ave them Sugino cranks please.... DIBS..... PM coming

2nd dibs on sugino cranks

Nice one cheers Black t. Still no PM though.

I need to shift all this stuff asap so If youre interested in anything make an offer. I'd rather give stuff away than it end up in landfill.

i'll take the guards if you'll post them. pm on it's way

Ok Guards now gone to Eone.

Black T im assuming you no longer want the cranks as I've not received a PM from you in 4 days.
So Dave, do you still want them?

Edit: Dave's & Kushandorangejuice are out on the cranks too.
They are still available.

cheers

Kushandorangejuice has taken the cranks

sorry mate , ive been in hospital again(Im disabled) , no access to computer.I know cranks gone but I hope my reason explains.

forks still available?

Sorry to hear that LukeSkywalker. I got a PM from you on the 16th saying you were no longer interested though?

Yep forks still available.

Forks and tyres now free if anyone wants them. I'd rather give them away that thrown them.
cheers
si

are the forks 1 1/8 and for 26"? if so dibs

coventry eagle pm'ed me on the 11th about the forks. Was going to pick them up yesterday. Do you still want them CE?