-
• #2
possibly people would need to know what crank and what length
do you want the same arm or just the same length (with a compatible bb taper)
-
• #3
Depending on the pedal thread, then you should be able to get an engineering or bicycle repair shop to put a thread inset in ( helicoil ). This will be only be possible if the correct thread form, pitch and diameter insert is available.
-
• #4
well have you done it all the way or just a couple of mil?
if you havent screwed the whole pedal in, crossing all threads and messing it up then phew!
try this: screw the pedal in from the other side, the inner edge, *without *cross-threading (do i need to say this?)
all the way and this should re align your threads. unscrew the pedal, then screw it in on the other (normal/usual) side of the crank. presto
Because I am a dozy fugger I have crossed the thread on the non drive side crank arm replacing a pedal.
Is there anything I can do other than buy a new one?
Cheers