You are reading a single comment by @meerlaan and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@meerlaan
Well I know this is not quite the right place for this post...
I have just stripped my carlton pro ready for powder coating, I am going to use a company near me that I have used before for powder coating but never a bike frame!!
I doubt these guys will have ever done a bike frame before and was wondering what I need to tell them to mask off?
Do all threads and holes need to be protected/covered ... ie brake hole, fork steerer, rear mech thread, seat tube?
Don't want to get it back and my seat tube wont fit or rear mech no longer screws on :D
I have no experience in this and would appreciate any information on this.
Thanks
Martin