You are reading a single comment by @nicklouse and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@nicklouse
there is the drop out, not at this moment planning on using any tensioners BUT the frame came with some and has cut-outs to locate the bolt, but using then would effect the rear hub bearings as they would not be pressing fully on the spacers.
So it may be back to the drawing board for a shorter axle but with screw in stub axle ends to allow the tensioners to be used.
but lets see how Mk1 goes first.