You are reading a single comment by @carson and its replies. Click here to read the full conversation.
  • i'm in the process of designing a headset press for a 1 1/8 threadless set up...

    (in before hammmer + wood block)

    ...and i want to make something that fits snugly inside the outer rim of the races (i.e where the cartridge bearings sit. but i dont have the headset to hand to measure the outer diameter of the cartridge bearings - does anyone know off hand how wide these usually are

    no idea if there is a standard but they must all be fairly similar in size...i'm guessing its going to be somewhere between 45-50 mm...

    (the headset this is being made for specifically is an M:Part Pro Alloy Aheadset 1-1/8")**
    **if the above in not clear i've indicated below in blue what it is i'm after.

About

Avatar for carson @carson started