Charge Scissor

yep thats why i would want to change to the fall guy, i like the rake being in the dropout and not in the leg. but the fall guy's axle to crowns are 2cm wrong in each size. very annoying.

Yeah i think i remember the guy saying something about that when i ordered mine.
I could measure what my modded a-c is tomorrow if you like?
I basically drilled a 10mm hole just above where the original slot ended and slightly back towards the leg and then cut through to the original slot and shaped it so the wheel would slot in ok.
So i reckon i'v dropped the a-c by at most 1cm but also brought the wheel closer to the leg so reduced the rake a wee bit.
I have to give the tyre a whack to get it out but its no too bad.