You are reading a single comment by @Re-cycled and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Re-cycled
I think you'l find how long it takes depends on the drill bits, a standard drill bit will take quite a while, but a titanium drill bit just goes through quite easily.
Another tip is rather then start with the 8mm bit, start with smaller drill bits and go increasing the size till the 8mm. It makes it easier and gives a better finish.
Cutting fluid also helps.