You are reading a single comment by @rik and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@rik
I just found this somewhere else
"using melted ABS is probably your best bet, you just need to chop up some scrap ABS into shavings (I used a big drill bit on some ABS and it made shavings very quickly), and then put them in some acetone. Play with the mixture until it comes out to your desired consistency. Make it in a squirt bottle, use it just like epoxy or whatever. This way, the entire work piece is made of ABS plastic so you shouldn't have problems with thermal expansion leading to cracks or separation like you can have with other materials."
"You only need acetone, no need for other products or ABS chips.
Just brush acetone on both pieces, join them and wait 5 minutes.
You will find that your two pieces now are literally one piece."