You are reading a single comment by @Dutch_Cheese and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Dutch_Cheese
I have the same "problem". Most sticker manuafacturers charge lots of $$$
I had one guy who said that he had a vinylcutter, but he wasn't able to read my EPS files and also couldn't get the decals right with Coraldraw files.
Now I ended up ordering trandfer paper / decal paper for a good laser colour printer at my office. I think it will arrive tomorrow and then I will run a few tests.
Finally, I should have a nice set of water slide decals.
After printing I probably have to "seal" them with clearcoat, cut them out by hand, apply to the frame and clearcoat again.
I hope it works out well.
The paper at not cheap, but if it works well, it's a very attractive way to reproduce decals.
I'll show it off in Current Projects, later.
http://progettopistavintage.blogspot.com/