You are reading a single comment by @playswellwithotters and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@playswellwithotters
here are some pics. The first is fairly obvious, just drill the hole in the golf club then drill the holes through the mallet head, and thread one through the other. (if you measure the head's radius beforehand, you can then drill the hole at the right spot on the golf club).
Put a cross bolt through and then put a nut on the other side. That's it. The ones picrured don't have a nut on the other side, because the holes in the new heads from Lucky are threaded.
http://static.londonfgss.com/memberpics1746-albums407-picture4314.jpg
http://static.londonfgss.com/memberpics1746-albums407-picture4312.jpg
http://static.londonfgss.com/memberpics1746-albums407-picture4313.jpg