Cone covers for Miche hub

Hi all,
I am trying to find some cone covers for Miche hub.

Does anyone have an idea where should i look to buy them or which other cone covers might be compatible?
cheers

your not the only one, after a quick google, other people are having the same problems.

perhaps go to yout local Bike shop and ask if you can try shimano dust covers to see if they fit. or other makes too, if they have them.

unfortunately shimy ones are smaller than miche. they are around 20mm in diameter and miche ones are 25 or 26mm. thanks anyway :-)

They seem to follow Campag patterns rather than Shimano ones, try Nigel Scott http://www.campyoldy.co.uk/[URL="http://www.campoldy.com"][/URL]

for some reason the webpage is down. hope it will load later on :-)

They seem to follow Campag patterns rather than Shimano ones, try Nigel Scott www.campyoldy.com

My mistake try http://www.campyoldy.co.uk/

great. i'll give him a call tomorrow to check if he's got something like that. cheers

My mistake try http://www.campyoldy.co.uk/

go to cranks in Brighton. they have a big pot of axles and other bits. they should be able to help you out

the only little problem is that i am prety far away from brighton:-)

go to cranks in Brighton. they have a big pot of axles and other bits. they should be able to help you out

make some......

milk bottle caps (the coloured plastic ones trim to shape )

make some......

milk bottle caps (the coloured plastic ones trim to shape )

Brilliant idea :-). I'll defo try that and I'll post the pix.
Cheers

Have you tried this yet ile?

TBH I was quite lazy for the last week or so. I got 2 caps cleaned and ready for the operation. I was just missing the driving force :-) I am gonna do it during this week and post up some pix :-) Cheers

Cool, i look forward to making these when i will lose my miche covers lol

bet way i found was to do this was buy....

http://www.modelzone.co.uk/circle_compass_cutter-details.htm

this puppy,messure the internal Dia. of the bearing race,half it then pierce the compas in the middle of the milk lid and run it round and round until the excess falls away.
messure the axel (9 or 10 mm) slightly smaller would give a better fit and may even thread on and just drill the centre hole that the compass made =]

SIMPLEZ