You are reading a single comment by @Sion and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Sion
new project bike is nearly done but when i went to tighten the chainset down it wont go in nice and flush to the frame, i can already see that the chainline wont be rideable like this.
Is my bottom bracket too long or am i better off mounting the chainring on the inside rather than the outside edge of the chainset-spider-bit (<insert correct term here)
the bottom bracket is the original square taper that came on my pug and the cranks are same as the white ones on here http://www.charliethebikemonger.com/userimages/procart7.htm
so close to finishing :(