I did a pair of spinergy carbon composite wheels.
I started with good sanding all over, to ruff up the surface.
Then a good clean with a degrease agent.
Then tape up, the parts you don’t want to spray.
Spray with a plasti kote or similar spray.
Keep your distance and hang wheel outside or in a garage, leave plenty of space so you can move around wheel.
Spay thin coats slowly, don’t rush build up painted surface slowly.It’s important to take your time so you get a smooth finish, let paint dry for a few hours don’t be tempted to take down until paint has completely dried
Or alternatively take to a paint shop.
I've just sprayed up my aerospoke in a quick and temporary job (black)
I used Molotow paint
Probably the cheapest option would be to do this.
Sand the surface so the paint has something to key into.
Loads of thin coats 1-2 cans per wheel.
Can of lacquer.
Roberts you mothers brother.
And if you're worried about your can control buy an extra can and practice.
You'd be suprised at how much easier it'd be to do this than strip the wheel and pay through the nose for Armourtex to do it.
Probably the cheapest option would be to do this.
Sand the surface so the paint has something to key into.
Loads of thin coats 1-2 cans per wheel.
Can of lacquer.
Roberts you mothers brother.
And if you're worried about your can control buy an extra can and practice.
You'd be suprised at how much easier it'd be to do this than strip the wheel and pay through the nose for Armourtex to do it.