-
• #9402
+1 on the ball bearing
-
• #9403
one ball bearing in the seat post clamp bolt
and another in the top saddle clamp- copious superglue.
it would take about 30 - 40 mins to remove.
much better than 10-15 seconds with a easily-concealed chaintool.
- copious superglue.
-
• #9404
one ball bearing in the seat post clamp bolt
and another in the top saddle clamp- copious superglue.
it would take about 30 - 40 mins to remove.
much better than 10-15 seconds with a easily-concealed chaintool.
or just lock it next to bike that look easier to steal.
job done.
- copious superglue.
-
• #9405
A Vivalo in their new OCEAN graphic design, your for $1090, fucking lush;
wish I have the money. -
• #9406
oh no
-
• #9407
.
-
• #9408
oh no
oh yes, something to replace the destoryed one from the tones of your post!
-
• #9409
not my idea of porn, but i'm sure it is someone's...
here it is built up…
-
• #9410
italy, ha? do you think is that easy?
-
• #9411
^great (@ the Charge). How big are those tyres !?!
If you glue a ball bearing into your seatpost clamp... how the fuck do you change post/saddles?
Thick grease and a magnet FTW.
-
• #9412
italy, ha? do you think is that easy?
?
-
• #9413
Thick grease and a magnet FTW.
genius !
-
• #9414
italy, ha? do you think is that easy?
...Wha?
-
• #9415
perfect for TrixieDix?
Glow in the dark Odyssey platforms… -
• #9416
keep your hate people -
• #9417
keep your hate peoplenice first post
-
• #9418
-
• #9419
i give up...cant' figure this blog out ...
-
• #9420
If you glue a ball bearing into your seatpost clamp... how the fuck do you change post/saddles?
Thick grease and a magnet FTW.
acetone will dissolve the glue easily. pick the bearing and remaining glue out with an awl or sharpened spoke. takes about 20 minutes, but it is not difficult - just time consuming.
do this once you're dialed in and do not need to change anything. if you're lowering or raising or changing the fore/oft of the saddle, just wait until you're 100% content - otherwise, it would be a pain in the ass to remove the glue/bearing on a regular basis.
-
• #9421
-
• #9422
Apologies, if a re-post.
-
• #9424
Hotdamn!
-
• #9425
'DICK POWER' made me laugh.
unbolt sign.
lift bike up and over.
chaintool to break saddle/seatpost chain in 10 seconds
both locks like flimsy. a leverage attack with a steel bar and some torque would snap those in a minute.
a ball bearing + superglue would be more secure and not look as retarded.