You are reading a single comment by @Richard_Cheese and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Richard_Cheese
My pedals axles are a bit fucked so I was toying with the idea of getting someone to spin me up some replacements out of stainless steel bar. Just wondering if
i)this is sensible/stupid/possible with stainless
ii) going to be time consuming and therefore unaffordable
The pedals are good, but spare parts aren't available.
Oh and they're cartridge bearings, so no need for bearing surfaces or any of that guff - just a bit of thread cutting on the inside at the outer end to accept a bolt and some flats obviously for the pedal wrench.
Any engineering expertise much appreciated