You are reading a single comment by @Richard_Cheese and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Richard_Cheese
I think you're about right there, cos if anything my spokes were a little on the long side - not enough to shit my pants about, but they could've been shorter without a problem.
However, to put it in a bit of context, getting the flange diameter out by 1mm means that your spoke length is out by a whole 0.2mm (which is less than the amount I rounded the lengths off by). You're not going to go far wrong.