You are reading a single comment by @lynx and its replies.
Click here to read the full conversation.
-
Did Santa bring you a welder ;)
From messing about with mig welders, basically you need the wire feed to be constant the same speed. Which is down to the a decent motor AND a power supply voltage and ampage that doesn't vary. That is the greatest issue with older wiring to sheds and garages. Even in houses.
What I found with cheap tigs and expensive tigs is the cycle, or how long you can weld continuously for.
lynx
Chaley
Hello
I can run a 30amp if needs be, but really want a 3 pin plug one as it’s only for smaller stuff.
I’ll head over to mig-welding and have a snout around ta.