You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
-
Boost hub will likely be a different shell as the disc mount needs to be in a different position.
You can make a non boost hub boost by adding a spacer, you'd need an inverse spacer to go boost to non boost.
M_V-
Depends if the DT swiss 240s hub is a 100x hub with assymetric end caps or a 110 specific one with symetrical.
Reverse situation: most 100 > 110 end cap conversions are assymetrical so to go 100 > 110 you just change drive side end cap and redish your wheel to centre rim accordingly (the disc mounts stay in position, extra 10mm added to drive side).
🅑🅐🅣🅣
Hey,
I'm installing a rigid fork on my XC Mountain bike and the forks come with a 100x15 axle.
It's a DT swiss 240s 6 bolt-boost hub, so i was planning on using these end caps HWGXXX00S4468S
but on a website it says that it's to convert from QR to thru axle, not reduce from Boost to TA. Is it really a problem?