You are reading a single comment by @oheyitsd and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@oheyitsd
Early Fugio frame which was basically a cyclocross race bike made from Reynolds 853. I had mudguard mounts added and had it powder coated by Steve at Aurum.
It currently has a Columbus futura gravel fork which is much more a road length fork but with good clearances and mudguard mounts, compared to the previous cyclocross fork. As a result it has pretty steep angles now, around 74 head tube.
The fork is actually 1 1/4 inch but the head tube is 1.5 inch. It has a reducer in there which works perfect. Fork is thru axle, rear dropouts QR
It will clear 42mm without guards and 35 with. The current guards are only 42mm but 45s will fit fine. I have some if you would like those instead.
Geometry Bare in mind the fork is now a different length.
Hope headset, Ultegra BB and seat clamp included, guards if desired. Takes a 27.2 post.
Small scratch on top tube pictured. It has top tube cable routing and guides for top pull FD but it has a problem solvers adapter to run bottom pull. Good segue into the fact that the mudguard mount which was added at the seat tube was put in at a cock angle and as a result, is useless. The problem solvers adapter is being used as the mudguard mount, it is solving two problems in one, that’s included.
£350 > £325 > £300 collected in N16
3 Attachments