You are reading a single comment by @cyclotron3k and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
bigshape
@cyclotron3k
CAD question: if I'm splitting a part with a surface (as above), what kind of gap should I introduce? I guess it varies a lot depending on various factors, and that a bit of trial and error is expected, but what would a typical value be?
EDIT: 0.2mm did the trick 🤌