You are reading a single comment by @pdlouche and its replies.
Click here to read the full conversation.
-
In @M_V ‘s case I think it’ll be a case of finding a small long end can that is as long as bearable, then fabricating the up and over header/link pipe.
There are lots of bolt-on options that way once link pipe diameter has been set/swaged.
HARD agree. we sell a lot of pro race silencers, coz they're cheap, but they sound horrible, wayyyy too loud. G&G are trying to figure out a way to replicate a flat track one-off silencer they made for us, but in a lower cost and street-friendly version. should go straight on OEM or most replacement headers [for the RnineT]. It's going to be stubby though so i don't think I'll run it on my bike.
sorry for derailling the thread a bit MV!