You are reading a single comment by @Aroogah and its replies.
Click here to read the full conversation.
-
In case you didn't find an answer
https://www.lfgss.com/conversations/199359/
I used this thread for my Goldtecs. Works fine.
In case you didn't find an answer
https://www.lfgss.com/conversations/199359/
I used this thread for my Goldtecs. Works fine.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Aroogah
How do I press new bearings into a goldtec track hub without special tools? The old bearings were drifted out with the axle. I’m sure there was a very good fixedgearlondon tutorial for this but I can’t find it