You are reading a single comment by @branwen and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
branwen
yup!
PDW 45s
The only tricky bit is getting the right length m3 screws to minimise fouling the tyre (can always cut some down too).
GoPro mount, here are a few links (UK or China), even come in silver for matchyness.
https://www.aliexpress.com/item/1005006973159164.html
https://www.ebay.co.uk/itm/176529503587
https://www.ebay.co.uk/itm/305721317843
Added a layer of 3M 8671HS tape for protection/vibration under the mount as PDW seem to do this with all the other fittings.
M3 nylon nuts
https://www.accu.co.uk/hexagon-nylon-locking-nuts/7944-HNN-M3-A2
M3 x 8mm cap head screws
https://www.accu.co.uk/metric-cap-head-screws/152194-SSCF-M3-8-A2-BL
M3 washers, pick an OD that works best
https://www.accu.co.uk/metric-flat-washers/391840-HAFLL-M3-A4-BL
Light holder
Pictured is from MagCAD, also recommend Cat3bits
https://www.etsy.com/uk/listing/1350122607/exposure-trace-side-entry-clip-for
https://www.ebay.co.uk/itm/294953997887
Think I'd avoid the Exposure version, far too easy for someone to nick at traffic lights.
Could have perphaps gone a little lower. Could go real low too and use as a secondary light to illuminate the road red.