You are reading a single comment by @alex_s and its replies. Click here to read the full conversation.
  • Out of interest, what settings are people using on their DF54s? I keep reading I should be using 20 to 18 for the robot, but it's way to difficult on the robot pressure wise, currently around 23 or 24. Is this just a maybe zero wasn't set properly issue?

    I know it doesn't really make much odds, but curious.

  • I suspect there might be some leeway on where the actual zero point is? Never tried seeing at what point burrs make contact, so not sure where my actual 0 point is, but I've been grinding at lower settings for that for my Gaggia Classic, anywhere between 5 and 15, with only a few instances of going closer to 20.

About

Avatar for alex_s @alex_s started