Home DIY

You are reading a single comment by @IrPOWERranger and its replies. Click here to read the full conversation.

•

konastab01 in reply to @IrPOWERranger

Tape them

•

IrPOWERranger in reply to @konastab01

I used tape first, about 15 wraps. The joints were spitting water.
This attempt is the entire thread covered in water hawk, plus more at the seal, before reassembling.

•

JonoMarshall in reply to @IrPOWERranger

You'll be able to see which join is leaking in that setup, is it the olive/15mm side, or coming out between the mixer unit and the 3/4" thread?

About

Avatar for IrPOWERranger @IrPOWERranger started