Wheelbuilding / Wheel Building / Wheel build help

You are reading a single comment by @Skülly and its replies. Click here to read the full conversation.

•

Skülly

I think I'd just use whatever a spoke calc gave for 24 holes ie the rim is where the larger variation in length will happen, the hub is really small beer in terms of hole positions in relation to rim hole, and in fact non-existent on the radial side.

•

Josh in reply to @Skülly

sure but the spoke calculator will assume there is equal spokes being used on both flanges.

Whereas we want 16 DS and 8 NDS
•

Netakure in reply to @Skülly

This. Do the spoke calc for standard 32h with crossing then do the same for radial. Don't mix sides and should be fine (I think)

About

Avatar for Skülly @Skülly started