KREG Rip-Cut
looks good and bookmarked it.
However, it presumably relies on the side it's push against to be straight, as opposed to clamping a straight edge (perhaps with help from a rafter square) and pushing against that?
Total newbie here
You should always make a straight cut to remove a factory edge before using anything that references that edge.
You can do that with your spirit level if it's long enough then use that edge as reference.
@Soul started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
looks good and bookmarked it.
However, it presumably relies on the side it's push against to be straight, as opposed to clamping a straight edge (perhaps with help from a rafter square) and pushing against that?
Total newbie here