Motorcycle and Scooter appreciation

You are reading a single comment by @Jung and its replies. Click here to read the full conversation.

•

pryally

I think I'm going bronze, local wheel place is £70 per wheel but needs bearings removed. I've done it on bicycle wheels is it the same but bigger bearings? and can I reuse as the rears appear to be £50!

•

Jung in reply to @pryally

You can't always get access to drift bearings out, If so, you have to use an extractor. They're little, steel cylinders with a deep slot that fit in the bearing race - you hammer a wedge into the slot and it grips the inside and pushes the bearings out.

I would never reuse wheel bearings.

•

lynx in reply to @Jung

Or just use expanding bolts. Cheaper than an extractor.

No, to reusing wheel bearings

About

@Jung started