You are reading a single comment by @Grumpy_Git and its replies.
Click here to read the full conversation.
-
Mine has been fine.
Are you saying you intentionally remove the wire? Spade connecters are not really made for repeated reconnections.
I would make sure you have a "thin" amount if insulation as this can act as a spring to force the connector loose over time if it is compressed in the available Space.If necessary also gently compress the connector before use to increase the clamping pressure of the female spade.
Grumpy_Git
sorethroat
Anyone have trouble with the Edelux II rear light connection dropping out? I find it bad to keep the shoe connector in the hole on the front light. Back light stopped working now because I think I've worn down the heat wrap too much and it's shorting by touching the metal of the light. The cable just drops out the hole though. Quite annoying. So every time I plug it back it gradually pushed down the heat sleeve/wrap to expose the metal.