You are reading a single comment by @Mr_Smyth and its replies.
Click here to read the full conversation.
-
Thanks, might even have some tails in box somewhere.
And if anyone has a deck mounted dual lever/mono lever with a decent throw they want to get rid of let me know. we have a fancy copper thing that was sent in error for our old place but I’m saving that for when the kitchen gets done properly.@grams Ah I have an adjustable wrench but those spanners look cheap enough, think I’ll tackle this once we have a cheap tap.
Mr_Smyth
kkg337
I’ve never bought a tap which came with push fit tails, usually compression but it’d probably be less hassle just to put a pair of push fit tails on a new tap than to try and fit a compression fitting in what is left above that T, and negligible cost difference.
Either a couple of these https://www.screwfix.com/p/flomasta-brass-compression-adapting-male-coupler-15mm-x-1-2-/69358 which usual tap tails will attach to with a nut,
Or
https://www.screwfix.com/p/jg-speedfit-push-fit-flexible-tap-connector-hoses-15mm-x-1-2-x-300mm-2-pack/9938g for the new tap.
But check sizing on the new tap obviously.