You are reading a single comment by @LukeG and its replies. Click here to read the full conversation.
  • Which bars are these? It does look like the bottom part of the bars are parallel to the ground and therefore more or less mounted correctly. But the top of the bars look too flat.
    No harm in rotating them down 1-2° and the move the levers up a bit as well. I would not worry about the clamp area as long as the levers can be tightened safely.

    Build is absolutely spot on tho!

  • Thanks!

    Might ask Thomson if it’s safe to clamp outside of the grip zone as I’d like to go a tiny bit higher. There’s a textured area of the carbon and these are at the max, unsure if it’s safe to clamp above this

About

Avatar for LukeG @LukeG started