bdhu

You are reading a single comment by @Hulsroy and its replies. Click here to read the full conversation.

•

LukeG

BDHU advice please. Looking to get this wrapped and lever bands are positioned at the maximum extent of the grip area on the bars. Bars are a little wider than I’d like anyway, is it time for new bars? -17° stem also required

•

Hulsroy in reply to @LukeG

Which bars are these? It does look like the bottom part of the bars are parallel to the ground and therefore more or less mounted correctly. But the top of the bars look too flat.
No harm in rotating them down 1-2° and the move the levers up a bit as well. I would not worry about the clamp area as long as the levers can be tightened safely.

Build is absolutely spot on tho!

•

LukeG in reply to @Hulsroy

Thanks!

Might ask Thomson if it’s safe to clamp outside of the grip zone as I’d like to go a tiny bit higher. There’s a textured area of the carbon and these are at the max, unsure if it’s safe to clamp above this

About

Avatar for Hulsroy @Hulsroy started