You are reading a single comment by @jackbepablo and its replies.
Click here to read the full conversation.
-
If at all possible, I'd replace the whole thing with a single, new, long length of the grey waste hose. You could use the existing hose(s) as a guide to pull the new one through from one end to the other - think internal cable routing with a bit of cotton thread etc. Disappointing from a brand new install!
-
Take the joint apart and put it back together with some Fernox LSX and you might save yourself the trouble of rerouting it all properly.
si_mon628
Airhead
@jackbepablo
I’m really stuck with this one - it’s so simple, I don’t get what could be wrong.
This joint is the waste from the washing machine, more or less as recently installed by the plumbers. They hadn’t routed the left hand one under something, so it had to be disconnected and reconnected.
I’m not 100% sure it didn’t drip before, but it does now. Only a little bit, but it’s all brand new so obv shouldn’t be dripping on the also new wood floor.
I’m going to try adjusting the exact position of the jubilee clip again, but I don’t get what I could be doing wrong.
Ideas on a postcard, please and thanks
1 Attachment