3D Printing service, including modelling

You are reading a single comment by @MrE and its replies. Click here to read the full conversation.

•

Light_EDDed

This piece

•

MrE in reply to @Light_EDDed

Not what you want to hear, but I suspect anything made directly with a domestic 3D printer is unlikely to survive long that close to the engine.

•

KDense in reply to @MrE

I fear that this is right. Some good ideas around moulds and adapters, but I’d suggest that that would have to be a last resort attempt where all other options are exhausted.

About

Avatar for MrE @MrE started