• I'm after the following for a turbo trainer setup

    165/170mm 50/34T crankset - 105, Ultegra, DA or Rotor (ideally), cosmetically less than perfect is fine, with good teeth 10/11 speed considered

    Also seeking a DI2 rear mech that supports 10 or 11speed setups and well as potentially a band-on front mech to match. Again, cosmetically less than perfect is fine but must be mechanically and electrically sound.

  • Have surplus Rotor 3D24 110bcd 5bolt 165mm crankarms. Very good condition.

  • Roughly how much??

  • I have r8000 stages dual sided power meter in 165mm, some cosmetic scratches on the inner drive side arm. Used around 1000kms, so chainring in pretty good condition.

    £245 posted anywhere in UK or can collect Newcastle for £240

  • lovely that a dual sided PM would be, this is going onto a frame that's alomost 100% going to sit attached to a V5 Kickr, which has a built in power meter, so that would be a bit OTT, TBH

  • Sadly @stickinsect never responded so I'm still seeking a 165/170mm chainset (24mm or 30mm axle)

    and odd Di2 kit - rear mech, poss front mech, battery and spare cables

  • Have BTR2 battery in E14. Looking for £35

  • Thanks, how old is it and how well does it hold charge

  • I bought it on here as used so I can’t comment on the age. All I can say is that it’s still a charge once and forget experience as with di2. I replaced it with the newer battery only to get the wireless connectivity and tempted by synchro shift

  • I’d potentially be interested in this if the OP isn’t. Would need it posting if poss.

  • I am interested, travelling up to London so may be able to collect later

  • I am still wavering whether to sell 165mm Aldhu cranks with Mas spider, you would need chainrings though. Interested?

  • @mattyc has di2 derailleurs i think ?

  • I'll be honest, that's probably a bit OTT for it's intended use (on a turbo setup)

    I'm thinking more older 110bcd Rotor 3D24 (or 3D30)

  • Might be interested in the crank arms if op isn't, if they're the 30mm version

  • I'm happy to step aside @jp

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

Seeking - 165/170mm 50/34 chainset (24mm or 30mm axle) plus DI2 bits

Posted by Avatar for tuttonp @tuttonp

Actions