You are reading a single comment by @retrodirect/glowbike and its replies.
Click here to read the full conversation.
-
The lasercut parts will arrive curved after all the holes are cut into them, but my 1x1 table ended up very flat (checked with feeler guage) once welded together. It took some time clamping to ensure all tabs are fully located all the way down. Rutland's sell some cheap sash clamps that help with that.
Attached a picture of the cheap 1x1 table we made (used for grinding and mig work), then one of the MAC industries trestles to show how they tab. Then the Siegmund table stuff we use all day every day.
Siegmund have bought out a new table which is about £1200 - 1200x800mm - worth the money if you use them alot, they pay for themselves.
Fishfabs
@retrodirect/glowbike
@Fishfabs
Is this from measurements of the finished table, or assumed from the lasercut tolerance?