You are reading a single comment by @bobble and its replies.
Click here to read the full conversation.
-
it isn't sealed on the inside at all. All the seal is on the outside and I remember this being a deliberate thing from the guy who (re) did it at the time cowboys left. So there are gaps inside
3 Attachments
-
bobble
-
And are you 100% sure that the seal is ok on the outer edge? It looked like there was some pealing. Unless it is sealed behind the bar when it’s installed then you only have that outer seal stopping anything coming through.
You could easily test it by pointing your shower head at the bar and standing on the outside to see if water is coming through (or see it coming through at any other point)
-
Yes, you’re not meant to seal both sides (so the water can get out)
-
Yes, as Fred says, you aren't supposed to seal both sides.
andos
fredtc
Howard
I would take all the silicone off and redo it, I can see a gap on the outside where the silicone won’t create a seal, unless it’s sealed behind the screen bar.