Replacing a steerer?

You are reading a single comment by @M_V and its replies. Click here to read the full conversation.

•

Chaley

I believe Gavin sleeved and TIGed it, he cut it so that the fork serial number is intact on the bit that was cut off. For posterity. Absolutely flawless job, I recommend them 100%

•

M_V in reply to @Chaley

Is the slight colour change what looks to be about an inch from the bottom of the thread the join? Or is it right down just above the crown?

As you say, flawless work. Must have chucked it on the lathe after to get it looking so consistent.

•

Chaley in reply to @M_V

That was my first thought, but the joint is way further down the tube than that.

About

Avatar for M_V @M_V started