-
Phew...I was worrying it had gone missing.
With regards to swapping, open the hypalon loop at the press stud, pull the hypalon off the part of the press stud that goes through the buckle, thread the desired hypalon section back through the buckle, then stretch the hole in the hypalon with the little slit back over the stud. I find stretching it over the side furthest from the buckle and stretching it towards the buckle works best, but basically just wiggle and flex it around until it pops over the stud. Then be sure to push the hypalon right down flat against the bottom bit so it's tucked properly under the stud.
If it's done right it should look like the hypalon was fitted under the stud in the regular way.That is as clear as crystal right? 😂
You are reading a single comment by @Black_Rainbow_Project and its replies.
Click here to read the full conversation.
Black_Rainbow_Project
Yes, it has just arrived. We've had an interrupted postal service here in SE24, which probably explains the delay.
It's beautiful, thanks!
Any hint on the correct way to interchange the two different end pieces?