You are reading a single comment by @hvsds and its replies.
Click here to read the full conversation.
-
Firstly, lol at the hydrophobic vinyl wrap!
I've used a potentially questionable trick, due to lack of power tools, which is clamping a straight edge/bit of wood I know is straight enough to what i'm cutting then using a generic hand saw to follow that - stops me veering off/getting too wonky.
Could use silicone sticky stuff/mitre bond and then screw it from the inside using 30mm screws that will grab-but-not-go-through (assuming 2x 18mm panels)?
hvsds
We've removed a bit of wall that covered the end of our kitchen units. We've sourced a replacement end panel which I need to fit.
What's the best way to do this? I was initially thinking of various solutions, but wondered if using something like Sticks Like Shit would be easiest. No screws or fixings, etc. I mean will I need to remove it? Or should I stop being so lazy and just screw from the inside of the other cupboard?
Also any tips for trimming it down neatly?