Pre 1950s rides of LFGSS: old bikes, vintage rats, classic lightweights

You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.

•

jeff80

My threads are intact but I have a feeling the extractor I was trying is for TA cranks so only .3 of a mm too small or something at 23mm. Didn't know about bearing pullers, maybe I should look into them ..

•

gbj_tester in reply to @jeff80
Didn't know about bearing pullers

You want this kind, you can get chinesium ones off of ebay or the house of bezos for about £30, get one with enough reach to do crown races while you're at it

1 Attachment

•

Foreigner65 in reply to @gbj_tester

How is this suppose to extract cranks on bottom bracket spindle with holes wider than the black thingy above? Not sure I understand what the point bit is resting on once you remove holding bolt?

About

Avatar for gbj_tester @gbj_tester started