Headset shim spacers

You are reading a single comment by @ep and its replies. Click here to read the full conversation.

•

lynx

Which bit are you after?

•

ep in reply to @lynx
I’m after the bit that goes between the top cover assembly and the compression ring that sits just above the bearing. They’re used on integrated headsets to get the compression ring deep enough. Cane creek manufacture some like shown.

1 Attachment

•

lynx in reply to @ep

Those usually go under the crown race on the fork.

You shouldn't need the shim on top. The top cover assembly, in the diagram, does that.

Additional-that is a diagram from cane creek

About

Avatar for ep @ep started