You are reading a single comment by @shinkuu_kiss and its replies.
Click here to read the full conversation.
-
Not any very good ones.
It's just held together at the joint by tension (the rod is bent inwards on both sides and the joint is pushing them out) so I can take it on and off easily if I want to. If I made it again I would put a straight joint on the front of it rather than on a corner. I would also measure and bend it a lot more evenly...
2 Attachments
-
shinkuu_kiss
-
It looks fantastic tbh.
I made this atrocity to use with a Carradice bagman. But in reality it’s too much of a faff to swap the bagman between the two bikes. So I’ll probably end up just buying a jack rack. But your example makes me think I should endure with a home brew solution. -
That looks well smart...how did you fix the copper onto the steel?
Nef
Josh
Any more photos of the bag support? Looks fantastic.