You are reading a single comment by @ibob and its replies.
Click here to read the full conversation.
-
The corrosion on the chain stay bridge doesn't look confidence-inspiring. Hopefully, your comment re 'looking worse than it is' applies.
-
Probably only way to do anything meaningfull to stop the corrosion on the bridge would be to strip, clean, prime and paint it with something with anti corrosive properties.
In the meantime, spray framesaver/Dinitrol inside all the rear frame tubes and get on with life? I’m pretty sure the rear guard on both of our bikes sits inside of the bridge rather than stopping right on it, can you play around with the position of the mount at the brake at all to make this happen as it means the water runs past the bridge rather than onto it?
JurekB
M_V
@ibob
was giving my 2016 raw lacquer a clean today & noticed a bit of rust starting at rub points on the rear triangle - I think it looks worse in the pics than it looks in person, but what could/should I be doing to keep this in check? long-term I'm fairly chill as it's an excuse to switch to kinetics / rohloff, but...
2 Attachments