You are reading a single comment by @damitamit and its replies.
Click here to read the full conversation.
-
I guess if it's tight it's not going to rattle. Or maybe you need a 3d printed cap that sit's over the lip of the thru axle with a 5mm hole.
damitamit-
@onyerbike - the above is done with QR skewers through the axle with the PDW 'fender' attachments acting as covers over the thru axle ends. Once 'tightened' they aren't rattling... but haven't used them extensively yet - will report back
mattyc
Am thinking about doing this myself with a rear Halo hex skewer. Am worried it will rattle though..