You are reading a single comment by @Greenbank and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Greenbank
apc
Want to replace tap in kitchen.
I believe the current flexi hose terminates with a male end piece. New tap came with female connector.
flexi hose (female) > male isolation valve > copper pipe, correct?
Anything to bear in mind when I take the old flexi hose off? As there is no isolation valve anywhere near, just the main stop cock I assume there could be a lot of water?
Will the old compression nut come off okay? Or might I need to cut the copper pipe?
Want to make sure I have everything required to avoid not having water. Due to the current lack of isolation valve if I fuck it up then no water for whole house :)