You are reading a single comment by @BartS and its replies.
Click here to read the full conversation.
-
This was my thought too: I had set it flush so the rotor could not spin and then back it up a bit which then caused metal bits. I tried to backed up a bit more and it appears that there is no more metal grinding. Now the plan is to properly clean it and see if the setting is good enough for an espresso.
BartS
I don't have that grinder but have you set the burrs too closer to each other? When I clean my Gaggia MDF I have to push the burrs closer and closer to each other until they touch and then step it back one to get a zero point for the grind indicator.