You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.
  • It’s made to the head tube dimensions they specify, with 3mm depth.

    Do you make a top cap that would rectify this?

  • Do you make a top cap that would rectify this?

    Measure the height from the top of the compression ring to top of the head tube while the ring is snug around the steerer. I have depths up to 4mm, which would suit a height measurement of 4.2-4.5mm

  • Orbea headset top cap measures 3mm deep
    Gap from Orbea top cap to head tube with specced compression ring is 1mm

    Height from top of standard compression ring to top of head tube is 4mm
    Height from top of Orbea compression ring to top of head tube is 4.2–5mm

About

Avatar for gbj_tester @gbj_tester started